Easel Peg Board Instructions by Michelle Egan
What you will need:
• 3 – 10ft pieces of 1 1/2 inch black pvc pipe
have lowes cut 3 pieces into 5 foot pieces, and 2 into 2 1/2 ft pieces this gives you 3, 5ft pieces and 2, 2 1/2 ft pieces)
• (4) 90 degree elbows, 1 1/2 inch size
• (1) end cap size 1 1/2 in.
• (1) t-shaped piece. the right and left sides are 2 in. and the botton is 1 1/2 in.
• 1/4 around screw that is 3 1/2 in long (you need 2 of them)
• 1/4 wing nut (need 2 of those)
• 1 inch washer, this has a 1/4 in hole in the center (need 2 of those)
• Black ribbon
• 1/4 in. drill bit and drill
Take all these pieces and assemble.
You need to create a rectangle with your pipe. you will have the t shape and the 3rd leg left. relase the top of the rectangle and slip the (t) onto it. then it will slide black and forth. Add the back leg. add cap to the back leg.
Depending on the size of the boards will determine where you want to put the screws and washers, this is what holds the board on the easel. you just drill a hold add washer to the screw, and tighter with the wing nut.
Drill holes in the bottom of each leg and thread the ribbon, this helps to keep the easel from slipping.
If you have question please send us and email and we’ll be sure to see what we can do to help you in creating this display.